Access Point Cisco Wireless 9171I Wi-Fi 7 - CW9171I-RTG

Product

Specifications

Part numbers

Cisco Wireless 9171 Access Points: Internal antennas

●  CW9171I model: Indoor access point with omnidirectional antennas

Software

Cisco IOS XE Software Release 17.18.2 or later

Cisco Meraki MR32.1.5 or later

Supported wireless LAN controllers

●  Cisco Catalyst 9800 Series Wireless Controllers (physical or virtual) ●  Cisco Catalyst 9000 switches with Embedded Wireless Controller in SD-Access mode.

802.11be

●  2x2 with two spatial streams (2.4 GHz, 5 GHz/6 GHz) ●  4096 quadrature amplitude modulation (QAM) ●  Multilink operation ●  Preamble puncturing ●  Uplink/downlink OFDMA ●  Target Wake Time (TWT) ●  BSS coloring ●  Maximal Ratio Combining (MRC) ●  20-, 40-, 80-, 160-, and 320-MHz channels (6 GHz) ●  20-, 40-, 80-, and 160-MHz channels (5 GHz) ●  20-MHz channels (2.4 GHz) ●  PHY data rates up to 6.0 Gbps (2x2 320 MHz on 6 GHz or 2x2 160 MHz on 5 GHz, and 2x2 20 MHz on 2.4 GHz) ●  Packet aggregation: Aggregate MAC Protocol Data Unit (A-MPDU) (transmit and receive), Aggregate MAC Service Data Unit (A-MSDU) (transmit and receive) ●  802.11 Dynamic Frequency Selection (DFS) ●  Cyclic Shift Diversity (CSD) support ●  Wi-Fi Protected Access 3 (WPA3) support

802.11ax

●  2x2 with two spatial streams (2.4 GHz, 5 GHz/6 GHz) ●  Uplink/downlink OFDMA ●  1024 QAM ●  TWT ●  BSS coloring ●  MRC ●  802.11ax beamforming ●  20-, 40-, 80-, and 160-MHz channels (5 and 6 GHz) ●  20-MHz channels (2.4 GHz) ●  PHY data rates up to 2.7 Gbps (2x2 20 MHz on 2.4 GHz, 2x2 160 MHz on 5 GHz, or 2x2 160 MHz on 6 GHz) ●  Packet aggregation: A-MPDU (transmit and receive), A-MSDU (transmit and receive) ●  802.11 DFS ●  CSD support ●  WPA2/WPA3 support

802.11ac

●  2x2 + 2x2 with 2 spatial streams ●  MRC ●  802.11ac beamforming ●  20-, 40-, 80-, and 160-MHz channels ●  PHY data rates up to 1.7 Gbps (2x2 160 MHz on 5 GHz) ●  Packet aggregation: A-MPDU (transmit and receive), A-MSDU (transmit and receive) ●  802.11 DFS ●  CSD support ●  WPA2/WPA3 support

Integrated antenna

●  2.4 GHz: Peak gain 4dBi, internal antenna, omnidirectional in azimuth ●  5 GHz: Peak gain 5.5dBi, internal antenna, omnidirectional in azimuth ●  6 GHz: Peak gain 6dBi, internal antenna, omnidirectional in azimuth ●  IoT: Peak gain 2dBi, internal antenna, omnidirectional in azimuth

802.11n version 2.0
(and related capabilities)

●  2x2 MIMO with two spatial streams ●  MRC ●  802.11n and 802.11a/g beamforming ●  20- and 40-MHz channels ●  PHY data rates up to 440 Mbps (2x2 40 MHz with 5 GHz and 2x2 20 MHz with 2.4 GHz) ●  Packet aggregation: A-MPDU (transmit and receive), A-MSDU (transmit and receive) ●  802.11 DFS ●  CSD support

Interfaces

●  1x 100M/1000M/2.5G Multigigabit Ethernet (RJ-45) uplink ●  Management console port (RJ-45) with default speed of 115200 bps ●  USB 2.0 at 4.5W ●  DC power jack, 54V

Incorporated radios

●  Wi-Fi 7 802.11be on all three radios ●  2.4 GHz + 5 GHz or 6 GHz (all 2x2:2) ●  Dedicated scan/aux radio and IoT (BLE 6) radio

Indicators

Status LED indicates boot loader status, association status, operating status, boot loader warnings, and boot loader errors

Dimensions (WxLxH)

CW9171I model (without mounting brackets):

●  7.8 x 7.8 x 2.1 in. (20 x 20 x 5.3 cm)

Weight

●  1.9 lb (874g)

Mounting brackets

●  AIR-AP-BRACKET-1 or AIR-AP-BRACKET-2

Input power requirements

Power source

2.4-GHz radio

5-GHz/6-GHz radio

USB

Link speed

802.3at (PoE+)

2x2

2x2

Yes

2.5G

802.3af (PoE)

1x1

-

-

1G

Power consumption

Power source

Idle

Typical

Dual radio 802.3at (PoE+)

9.8W ± 2W

11.4W ± 4W

Note: Actual power consumption may vary depending on access point usage. Typical power consumption assumes the access point is passing traffic* during typical business hours and is idle during off-business hours. Business hours are assumed to be 11 hours a day, 6 days a week.

* Test conditions:

Dual radio 802.3at: The 5-GHz band operating at 160 MHz (2x2) passing 200 Mbps per band of download traffic and the 2.4-GHz band operating at 20 MHz (2x2) passing 50 Mbps of download traffic; USB disabled; 2.5G Ethernet port; ambient temperature 25˚C (77°F).

Environmental

●  Nonoperating (storage) temperature: -40˚ to 158˚F (-40˚ to 70˚C) ●  Non-operating (storage) altitude test: 0 to 550 mbar (at approx. 4863m, 16,000 ft) ●  Operating temperature: 32˚ to 122˚F (0˚ to 50˚C) ●  Radio operation derated for 104˚F to 122˚F (40˚C to 50˚C) ●  Operating humidity: 0% to 95% (noncondensing) ●  Operating altitude test: 50˚C (122˚F) at 0 to 4205m (13,800 ft)

Available transmit power settings

2.4 GHz:

●  20 dBm (100 mW) ●  -10 dBm (0.1 mW)

5 GHz:

●  20 dBm (100 mW) ●  -10 dBm (0.1 mW)

6 GHz:

●  20 dBm (100 mW) ●  -10 dBm (0.1 mW)

Note: In countries where use of the 6-GHz band is not allowed or there is no current software support, the 6-GHz radio will be disabled. The radio may be enabled with future software, once the product is certified to operate in 6 GHz for that country.

Compliance standards

●  Safety: ◦  IEC 60950-1 / IEC 62368-1 Ed.3 (with Ed.2 Deviation annex) ◦  EN 60950-1 / EN 62368-1 Ed.3 (with Ed.2 Deviation annex) ◦  UL 60950-1 / UL62368-1 3rd (with Ed.2 Deviation annex) ◦  CAN/CSA-C22.2 No. 60950-1 / CAN/CSA-C22.2 No. 62368-1 3rd (with Ed.2 Deviation annex) ◦  AS/NZS60950.1 / AS/NZS62368.1 Ed.3 (with Ed.2 Deviation annex) ◦  UL 2043 ◦  Class III equipment ●  Emissions: ◦  CISPR 32 (rev. 2015) +AMD1:2019 ◦  EN 55032:2015/A11:2020 ◦  EN IEC 61000-3-2:2019/A1:2021 ◦  EN 61000-3-3:2013+A1:2019 ◦  AS/NZS CISPR32: 2015+AMD1:2020 ◦  47 CFR FCC Part 15B ◦  ICES-003 (Issue 7, Class B) ◦  VCCI-CISPR 32:2016 ◦  CNS 13438:2006 (95) ◦  KS C 9832:2019 ◦  QCVN 118:2018/BTTTT ●  Immunity: ◦  EN 55035:2017+A11:2020 ◦  KS C 9835:2019 ●  Emissions and immunity: ◦  EN 301 489-1 V2.2.3 (2019-11) ◦  EN 301 489-17 V3.2.4 (2020-09) ◦  QCVN (18:2014) ◦  QCVN 112:2017/BTTTT ◦  KS X 3124:2020 ◦  KS X 3126:2020 ◦  EN 61000-6-1:2019 ◦  EN 60601-1-2:2015+A1:2021

●  Radio: ◦  EN 300 328 (v2.2.2) ◦  EN 301 893 (v2.1.1) ◦  EN 303 687 (v1.1.1) ◦  AS/NZS 4268 (rev. 2017) ◦  47 CFR FCC Part 15C, 15.247, 15.407 ◦  RSP-100 ◦  RSS-GEN ◦  RSS-247 ◦  LP0002 (109) ◦  Japan Std. 66, and Std. 71 ●  RF safety: ◦  EN 50385:2017 ◦  AS/NZS 2772 (rev. 2016) ◦  47 CFR Part 2.1091 ◦  RSS-102 ◦  IEEE standards: ◦  IEEE 802.3 ◦  IEEE 802.3ab ◦  IEEE 802.3af/at ◦  IEEE 802.11a/b/g/n/ac/ax/be ◦  IEEE 802.11h, 802.11d ●  Security: ◦  802.11i (WPA2, WPA3) ◦  802.1x/802.1x - SHA256 ◦  Enhanced Open/OWE ◦  Advanced Encryption Standard (AES) - GCMP128, GCMP256 and CCMP256 ●  Extensible Authentication Protocol (EAP) types: ◦  EAP-Transport Layer Security (TLS) ◦  EAP-Tunneled TLS (TTLS) or Microsoft Challenge Handshake Authentication Protocol (MSCHAP) v2 ◦  Protected EAP (PEAP) v0 or EAP-MSCHAP v2 ◦  EAP-Flexible Authentication via Secure Tunneling (EAP-FAST) ◦  PEAP v1 or EAP-Generic Token Card (GTC) ◦  EAP-Subscriber Identity Module (SIM)

Certifications

●  Wi-Fi Alliance: Wi-Fi 7 (R1), Wi-Fi 6 (R2), Wi-Fi 6E, WPA3-R3, WPA3-Suite B, Enhanced Open Security ●  Bluetooth SIG: Bluetooth Low Energy